View source for KAVAN Smart PRO telemetry Lua applications - Setup manual

=== Introduction ===
Smart PRO speed controllers, telemetry and power management units seamlessly communicate with your ETHOS radio. Lua applications are used to program the Smart PRO ESC.

=== Setting up ===
The method consists of 3 phases:
<ol style="list-style-type:upper-alpha">
  <li>Preparing the Lua script</li>
  <li>Unit wiring</li>
  <li>Setting up and operating the telemetry</li>
</ol>

=== A. Preparing the Lua script ===
# Download files for Lua scripts - controller setup applications: [https://kavanrc.com/files/KAV_LUA.zip kavanrc.com/files/KAV_LUA.zip]
# Extract the "KAV_LUA.zip"
# Select the folder with the required script, e.g. "smart_pro" for the KAVAN Smart PRO series of controllers
# Switch on the KAVAN V20 transmitter 
# Connect the transmitter to a PC using a USB-C to USB-A 2.0 cable.
# A pop-up window will appear on the transmitter, select "ETHOS Suite"
# Upload the "smart_pro" folder to the transmitter's memory RADIO:/scripts
# Disconnect the transmitter from the PC and turn off the transmitter.

=== B. Unit wiring ===

=== C. Setting up and operating the telemetry ===
<ol>
<li>'''Telemetry setup'''<br>
Assuming that the registration and pairing of the receiver is correct, check or enable the following options:<br>
In Model Settings → RF System<br>
[[File:V20 - Lua 1.bmp|frameless|360x360px]]<br><br>
Select the receiver to which the KAVAN Smart PRO controller is paired<br>
[[File:V20 - Lua 2.bmp|frameless|360x360px]]<br><br>
Select the "Options" of the receiver<br>
[[File:V20 - Lua 3.bmp|frameless|360x360px]]<br><br>
For proper functionality, telemetry must be enabled and the telemetry port must be set to "F.Port", see Fig.<br>
[[File:V20 - Lua 4.bmp|frameless|360x360px]]<br><br></li>

<li> '''Putting telemetry into operation'''<br>
In the section Model settings → Telemetry<br>
[[File:V20 - Lua 5.bmp|frameless|360x360px]]<br><br>
Select Discover new sensors<br>
[[File:V20 - Lua 6.bmp|frameless|360x360px]]<br><br>
The telemetry data of the controller and receiver should already be displayed in the list below.<br>
[[File:V20 - Lua 7.bmp|frameless|360x360px]]<br><br></li>

<li> '''Application settings'''<br>
In the System → KAVAN Smart section <br>
[[File:V20 - Lua 8.bmp|frameless|360x360px]]<br><br></li>