FuzzyBot: Importing a new version from external source

2025-10-31T12:22:46Z

Importing a new version from external source

← Older revision		Revision as of 14:22, 31 October 2025
Line 1:		Line 1:
	==== Setting the High Speed Needle Valve ====		==== Setting the High Speed Needle Valve ====
	1) Start the engine and remove the glow starter from the glow plug. Allow the engine to warm up for about 1 minute.		# Start the engine and remove the glow starter from the glow plug. Allow the engine to warm up for about 1 minute.
			# After the engine has warmed up, advance the throttle to full and slowly lean the high speed valve until the engine reaches peak R.P.M. After reaching peak R.P.M. richen the mixture slightly until an audible drop in R.P.M. is heard. If you are using a tachometer this should be between a 200 - 300 R.P.M. drop.
			# With the engine running at full power, carefully lift the nose of the airplane about 45° into the air. The mixture should not become too lean, but you may hear a slight increase in R.P.M. This is good. If the engine sags, or loses R.P.M. when you hold the nose up, the mixture is too lean and should be set slightly richer. The engine should always exhibit a noticeable smoke trail from the exhaust.
			{{Note\|type=info\|text='''Note:''' R.P.M. will increase about 10% - 30% in the air. This is due to the forward motion of the aircraft as it is flying. Because of this forward motion, more air is entering the carburettor, at a higher force, and causes the mixture to lean out. Additionally, as the fuel level in the fuel tank goes down, fuel draw becomes more difficult for the engine, especially during aerobatics, also causing the mixture to go lean. It is imperative that you set the mixture rich while on the ground to compensate for the leaning tendencies that will happen in the air. Always watch the exhaust during your flight. The engine should leave a noticeable white smoke trail at all times. It there is no smoke trail, the engine is running too lean. You should land immediately and reset the mixture.}}

FuzzyBot: FuzzyBot moved page Translations:Kavan AP06A - Instruction Manual/79/en to Translations:KAVAN AP06A - Instruction Manual/79/en without leaving a redirect: Part of translatable page "Kavan AP06A - Instruction Manual"

2025-10-15T09:24:07Z

FuzzyBot moved page Translations:Kavan AP06A - Instruction Manual/79/en to Translations:KAVAN AP06A - Instruction Manual/79/en without leaving a redirect: Part of translatable page "Kavan AP06A - Instruction Manual"

← Older revision		Revision as of 11:24, 15 October 2025
(No difference)

FuzzyBot: Importing a new version from external source

2025-08-06T05:26:14Z

Importing a new version from external source

New page

==== Setting the High Speed Needle Valve ====
1) Start the engine and remove the glow starter from the glow plug. Allow the engine to warm up for about 1 minute.

Translations:KAVAN AP06A - Instruction Manual/79/en - Revision history

FuzzyBot: Importing a new version from external source

FuzzyBot: FuzzyBot moved page Translations:Kavan AP06A - Instruction Manual/79/en to Translations:KAVAN AP06A - Instruction Manual/79/en without leaving a redirect: Part of translatable page "Kavan AP06A - Instruction Manual"

FuzzyBot: Importing a new version from external source