FuzzyBot: Importing a new version from external source

2024-05-09T10:31:36Z

Importing a new version from external source

New page

# Locate the steel wire wing joiner (note the "V" shape ensuring the correct wing dihedral) and slide both wing halves onto the joiner. '''(Fig. 1)'''
# Connect the aileron servo cables to the corresponding extension cables in the wing opening in the fuselage. '''(Fig. 2)'''<br>{{Note|type=info|text='''Note:''' The kit is supplied with a Y-cable for ailerons so you can use even the most basic 4-channel radios to control your FALKE 1800. If you intend to use independent control of aileron servos and an advanced computer radio, you will have to replace the default Y-cable with two 25–30 cm extension cables.}}
# Attach the plastic wing joiner and secure the wing to the fuselage with two M5×20 mm nylon bolts. '''(Fig. 3)'''
# Attach the V-tail planes to the tailplane seat and secure them with the plastic joiner and M3 hex screw to the fuselage. '''(Fig. 4)'''
# Connect the plastic quick links to the ruddervator horns. '''(Fig. 5)'''
# The flight pack is to be placed in the bay in the centre of the cockpit; use a Hook-and-loop tie to fasten it. You can place your receiver (secured with a strip of Hook-and-loop or double-sided foam tape) behind the flight pack. Connect servos and your ESC to the receiver; deploy the antennas so their active parts are square to each other (if you are using a receiver featuring diversity antennas). With your radio on, set the servos to the neutral position (sticks and trims centred) - screw in or out the quick links as needed. Perform the throttle range calibration of the ESC as described in the attachment of this manual. '''(Fig. 6)'''
# Attach the canopy.

Translations:KAVAN Falke 1800mm ARF - Instruction manual/18/en - Revision history

FuzzyBot: Importing a new version from external source