FuzzyBot: Importing a new version from external source

2025-01-08T08:25:52Z

Importing a new version from external source

← Older revision		Revision as of 10:25, 8 January 2025
Line 1:		Line 1:
	=== RC set installation and preflight check ===		=== RC set installation and preflight check ===
	Referring to the instruction manual of your radio carefully hook up the on-board electronics. Once everything has been correctly connected, turn on your transmitter and plug in the flight (receiver) pack. Check the neutral positions and throws of all control surfaces. If you ~~needed~~ to make the control surface throws smaller, simply move the pushrod closer to the centre on the servo arm or move it far from the control surface on the control horn. And vice versa.		Referring to the instruction manual of your radio carefully hook up the on-board electronics. Once everything has been correctly connected, turn on your transmitter and plug in the flight (receiver) pack. Check the neutral positions and throws of all control surfaces. If you need to make the control surface throws smaller, simply move the pushrod closer to the centre on the servo arm or move it far from the control surface on the control horn. And vice versa.
	{\| class="wikitable"		{\| class="wikitable" style="text-align: center; width: 100%;"
	\| rowspan="2" \|'''Recommended throws'''		\| rowspan="2" \|'''Recommended throws'''
	\| colspan="2" \|'''Low rate'''		\| colspan="2" \|'''Low rate'''

FuzzyBot: Importing a new version from external source

2024-05-30T08:24:28Z

Importing a new version from external source

New page

=== RC set installation and preflight check ===
Referring to the instruction manual of your radio carefully hook up the on-board electronics. Once everything has been correctly connected, turn on your transmitter and plug in the flight (receiver) pack. Check the neutral positions and throws of all control surfaces. If you needed to make the control surface throws smaller, simply move the pushrod closer to the centre on the servo arm or move it far from the control surface on the control horn. And vice versa.
{| class="wikitable"
| rowspan="2" |'''Recommended throws'''
| colspan="2" |'''Low rate'''
| colspan="2" |'''High rate'''
|-
|'''Rate'''
|'''Expo'''
|'''Rate'''
|'''Expo'''
|-
|Ailerons
|± 5 mm
|30–40 %
|± 7 mm
|40–50 %
|-
|Elevator
|± 7 mm
|30–40 %
|± 10 mm
|40–50 %
|-
|Rudder
|± 11 mm
|30–40 %
|± 15 mm
|50 %
|}
The "Low rate" recommended control surface throws are suitable for a less skilled pilot and classic pattern aerobatics. The "High rate" setting is for 3D aerobatics and skilled pilots.

Translations:KAVAN FunStik 1280mm kit - Instruction manual/71/en - Revision history

FuzzyBot: Importing a new version from external source

FuzzyBot: Importing a new version from external source