FuzzyBot: Importing a new version from external source

2024-08-29T09:57:02Z

Importing a new version from external source

← Older revision		Revision as of 11:57, 29 August 2024
Line 1:		Line 1:
	==== ESC/radio calibration ====		==== ESC/radio calibration ====
	# Turn on the transmitter and move the throttle stick to the top position.		# Turn on the transmitter and move the throttle stick to the top position.
	# Connect a battery to the ESC; the motor will ~~sound~~ "123" to indicate the ESC is powered on.		# Connect a battery to the ESC; the motor will emit "♪ 123" to indicate the ESC is powered on.
	# Then the motor will beep two short beeps to indicate the maximum throttle endpoint is accepted.		# Then the motor will beep two short beeps to indicate the maximum throttle endpoint is accepted.
	# Move the throttle stick to the bottom position within 5 seconds after the two short beeps, the minimum throttle position will be accepted 1 second later.		# Move the throttle stick to the bottom position within 5 seconds after the two short beeps, the minimum throttle position will be accepted 1 second later.
Line 8:		Line 8:
	==== Normal ESC start-up procedure ====		==== Normal ESC start-up procedure ====
	# Turn on the transmitter, and then move the throttle stick to the bottom position.		# Turn on the transmitter, and then move the throttle stick to the bottom position.
	# After connecting the ESC to a battery, the motor will emit "123" to indicate the ESC is normally powered on.		# After connecting the ESC to a battery, the motor will emit "♪ 123" to indicate the ESC is normally powered on.
	# The motor will emit several beeps to indicate the number of LiPo cells.		# The motor will emit several beeps to indicate the number of LiPo cells.
	# The motor emits a long beep to indicate the ESC is ready to go.		# The motor emits a long beep to indicate the ESC is ready to go.

FuzzyBot: Importing a new version from external source

2024-05-10T09:29:16Z

Importing a new version from external source

New page

==== ESC/radio calibration ====
# Turn on the transmitter and move the throttle stick to the top position.
# Connect a battery to the ESC; the motor will sound "123" to indicate the ESC is powered on.
# Then the motor will beep two short beeps to indicate the maximum throttle endpoint is accepted.
# Move the throttle stick to the bottom position within 5 seconds after the two short beeps, the minimum throttle position will be accepted 1 second later.
# The motor will beep "Number" beeps to indicate the number of LiPo cells you have plugged in.
# The motor will beep a long beep to indicate the calibration is complete.
==== Normal ESC start-up procedure ====
# Turn on the transmitter, and then move the throttle stick to the bottom position.
# After connecting the ESC to a battery, the motor will emit "123" to indicate the ESC is normally powered on.
# The motor will emit several beeps to indicate the number of LiPo cells.
# The motor emits a long beep to indicate the ESC is ready to go.

Translations:KAVAN Plus ESCs - Instruction manual/8/en - Revision history

FuzzyBot: Importing a new version from external source

FuzzyBot: Importing a new version from external source