FuzzyBot: Importing a new version from external source

2024-05-15T11:03:33Z

Importing a new version from external source

← Older revision		Revision as of 13:03, 15 May 2024
Line 1:		Line 1:
	# Turn off power to the receiver.		# Turn off power to the receiver.
	# Selecting [Pairing], a pop-up window will appear with a selection of channels, once selected, start the pairing process. Every few seconds, a ~~„Pairing“~~ voice alert will sound to confirm that you are in pairing mode. The pop-up window will display the message „ Pairing ...“.		# Selecting [Pairing], a pop-up window will appear with a selection of channels, once selected, start the pairing process. Every few seconds, a "Pairing" voice alert will sound to confirm that you are in pairing mode. The pop-up window will display the message "Pairing ...".
	# Turn on the receiver, while holding the pairing button F/S. A window will appear with the message „ Select ~~Device“~~ and the name of the receiver you just turned on.		# Turn on the receiver, while holding the pairing button F/S. A window will appear with the message "Select Device" and the name of the receiver you just turned on.
	# Scroll to the receiver name and select it. A window will appear with a message that the pairing was successful. Switch off the transmitter and receiver. Switch on the transmitter and then the receiver. If the green LED on the receiver is lit and the red LED is not lit, the receiver is connected to the transmitter. The pairing of the receiver and transmitter will not need to be repeated unless one is replaced.		# Scroll to the receiver name and select it. A window will appear with a message that the pairing was successful. Switch off the transmitter and receiver. Switch on the transmitter and then the receiver. If the green LED on the receiver is lit and the red LED is not lit, the receiver is connected to the transmitter. The pairing of the receiver and transmitter will not need to be repeated unless one is replaced.
	* The receiver will only be controlled by the transmitter it is paired to. Other transmitters in its vicinity will not affect its operation.		* The receiver will only be controlled by the transmitter it is paired to. Other transmitters in its vicinity will not affect its operation.
	* The name of the RX1 receiver will now be displayed next to the selected receiver.		* The name of the RX1 receiver will now be displayed next to the selected receiver.
	* The receiver is now ready for use.		* The receiver is now ready for use.

FuzzyBot: Importing a new version from external source

2024-03-11T10:15:02Z

Importing a new version from external source

New page

# Turn off power to the receiver.
# Selecting [Pairing], a pop-up window will appear with a selection of channels, once selected, start the pairing process. Every few seconds, a „Pairing“ voice alert will sound to confirm that you are in pairing mode. The pop-up window will display the message „ Pairing ...“.
# Turn on the receiver, while holding the pairing button F/S. A window will appear with the message „ Select Device“ and the name of the receiver you just turned on.
# Scroll to the receiver name and select it. A window will appear with a message that the pairing was successful. Switch off the transmitter and receiver. Switch on the transmitter and then the receiver. If the green LED on the receiver is lit and the red LED is not lit, the receiver is connected to the transmitter. The pairing of the receiver and transmitter will not need to be repeated unless one is replaced.
* The receiver will only be controlled by the transmitter it is paired to. Other transmitters in its vicinity will not affect its operation.
* The name of the RX1 receiver will now be displayed next to the selected receiver.
* The receiver is now ready for use.

Translations:KAVAN V20 - Quickstart guide/33/en - Revision history

FuzzyBot: Importing a new version from external source

FuzzyBot: Importing a new version from external source