Translations:KAVAN Dara A1 (F1H) glider kit 1200mm - Instruction manual/39/en: Difference between revisions

From KAVAN RC Wiki
(Importing a new version from external source)
 
 
(One intermediate revision by the same user not shown)
(No difference)

Latest revision as of 13:26, 11 December 2024

Message definition (KAVAN Dara A1 (F1H) glider kit 1200mm - Instruction manual)
{{Note|'''Important:''' One loop is never enough!|type=warn}}Drill 5 mm access hole into the additional ballast compartment in the fuselage (refer to the building plan). Support the wing of the model with your fingertips in the centre of gravity position (the point marked by an arrow on the fuselage plan). The fuselage should be level - if the nose pitches up put in as much of additional ballast (not supplied in the kit) as necessary (you can use pellets, small screws etc.) Once satisfied, cover the hole with a strip of clear sticky tape.
Important: One loop is never enough!

Drill 5 mm access hole into the additional ballast compartment in the fuselage (refer to the building plan). Support the wing of the model with your fingertips in the centre of gravity position (the point marked by an arrow on the fuselage plan). The fuselage should be level - if the nose pitches up put in as much of additional ballast (not supplied in the kit) as necessary (you can use pellets, small screws etc.) Once satisfied, cover the hole with a strip of clear sticky tape.

Retrieved from "https://wiki.kavanrc.com/index.php?title=Translations:KAVAN_Dara_A1_(F1H)_glider_kit_1200mm_-_Instruction_manual/39/en&oldid=27871"