Translations:KAVAN FunStik 1280mm kit - Instruction manual/69/en: Difference between revisions

From KAVAN RC Wiki
VisualWikitext
(Importing a new version from external source)
 
(Importing a new version from external source)
 
Line 1: Line 1:
50. Secure the control surfaces using strips of masking tape or other suitable means in the neutral (centre) position. Tack fit the control horns with a piece of thin double sided sticky tape to the respective control surfaces so the holes for pushrod in the horns were in line with the hinge pins. Mark the correct length of the push rods and make Z-bends on them. Thread the horns on the Z-bends and secure the horns to the control surfaces with screws. Alternatively you can install push rod connectors (e.g. [https://www.kavanrc.com/item/threaded-pushrod-connector-m2-d-1-25mm-10-pcs-108746 KAVAN KAV3060A/10] - not supplied in the kit) to the servo arms that will allow precise setting of the control linkage any time.
50. Secure the control surfaces using strips of masking tape or other suitable means in the neutral (centre) position. Tack fit the control horns with a piece of thin double-sided sticky tape to the respective control surfaces so the holes for pushrod in the horns were in line with the hinge pins. Mark the correct length of the push rods and make Z-bends on them. Thread the horns on the Z-bends and secure the horns to the control surfaces with screws. Alternatively, you can install push rod connectors (e.g. [https://www.kavanrc.com/item/threaded-pushrod-connector-m2-d-1-25mm-10-pcs-108746 KAVAN KAV3060A/10] - not supplied in the kit) to the servo arms that will allow precise setting of the control linkage any time.

Latest revision as of 09:25, 8 January 2025

Message definition (KAVAN FunStik 1280mm kit - Instruction manual)
50. Secure the control surfaces using strips of masking tape or other suitable means in the neutral (centre) position. Tack fit the control horns with a piece of thin double-sided sticky tape to the respective control surfaces so the holes for pushrod in the horns were in line with the hinge pins. Mark the correct length of the push rods and make Z-bends on them. Thread the horns on the Z-bends and secure the horns to the control surfaces with screws. Alternatively, you can install push rod connectors (e.g. [https://www.kavanrc.com/item/threaded-pushrod-connector-m2-d-1-25mm-10-pcs-108746 KAVAN KAV3060A/10] - not supplied in the kit) to the servo arms that will allow precise setting of the control linkage any time.

50. Secure the control surfaces using strips of masking tape or other suitable means in the neutral (centre) position. Tack fit the control horns with a piece of thin double-sided sticky tape to the respective control surfaces so the holes for pushrod in the horns were in line with the hinge pins. Mark the correct length of the push rods and make Z-bends on them. Thread the horns on the Z-bends and secure the horns to the control surfaces with screws. Alternatively, you can install push rod connectors (e.g. KAVAN KAV3060A/10 - not supplied in the kit) to the servo arms that will allow precise setting of the control linkage any time.

Retrieved from "https://wiki.kavanrc.com/index.php?title=Translations:KAVAN_FunStik_1280mm_kit_-_Instruction_manual/69/en&oldid=29624"