Translations:KAVAN Smart PRO TW30 Power switch with telemetry - Instruction manual/10/en: Difference between revisions

From KAVAN RC Wiki
VisualWikitext
(Importing a new version from external source)
 
(Importing a new version from external source)
 
Line 2: Line 2:
* Place the touch button anywhere on your model on a surface made of nonconductive material. You can place the touch button also inside the fuselage with a maximum thickness of up to 3 mm.
* Place the touch button anywhere on your model on a surface made of nonconductive material. You can place the touch button also inside the fuselage with a maximum thickness of up to 3 mm.
* Make the status LED visible from outside the fuselage and put the “touch” sticker on top of the touch surface.
* Make the status LED visible from outside the fuselage and put the “touch” sticker on top of the touch surface.
* Connect the receiver battery to the Voltario and briefly touch the button. The status LED should blink once. If not, please increase the touch sensitivity parameter in the configuration.
* Connect the receiver battery to the TW30 and briefly touch the button. The status LED should blink once. If not, please increase the touch sensitivity parameter in the configuration.
* Touch and hold the button for about 2 seconds. After the initial blink, the LED will start blinking again. At this moment, release the button. The main output will be activated:
* Touch and hold the button for about 2 seconds. After the initial blink, the LED will start blinking again. At this moment, release the button. The main output will be activated:
[[File:TW30 - Touch switch behaviour.png|center|frameless|640x640px]]
[[File:TW30 - Touch switch behaviour.png|center|frameless|640x640px]]

Latest revision as of 13:15, 27 January 2025

Message definition (KAVAN Smart PRO TW30 Power switch with telemetry - Instruction manual)
====Touch switch behaviour====
* Place the touch button anywhere on your model on a surface made of nonconductive material. You can place the touch button also inside the fuselage with a maximum thickness of up to 3 mm.
* Make the status LED visible from outside the fuselage and put the “touch” sticker on top of the touch surface.
* Connect the receiver battery to the TW30 and briefly touch the button. The status LED should blink once. If not, please increase the touch sensitivity parameter in the configuration.
* Touch and hold the button for about 2 seconds. After the initial blink, the LED will start blinking again. At this moment, release the button. The main output will be activated:
[[File:TW30 - Touch switch behaviour.png|center|frameless|640x640px]]

Touch switch behaviour

  • Place the touch button anywhere on your model on a surface made of nonconductive material. You can place the touch button also inside the fuselage with a maximum thickness of up to 3 mm.
  • Make the status LED visible from outside the fuselage and put the “touch” sticker on top of the touch surface.
  • Connect the receiver battery to the TW30 and briefly touch the button. The status LED should blink once. If not, please increase the touch sensitivity parameter in the configuration.
  • Touch and hold the button for about 2 seconds. After the initial blink, the LED will start blinking again. At this moment, release the button. The main output will be activated:
Retrieved from "https://wiki.kavanrc.com/index.php?title=Translations:KAVAN_Smart_PRO_TW30_Power_switch_with_telemetry_-_Instruction_manual/10/en&oldid=31390"