Translations:KAVAN Long sticks - Installation manual/9/en: Difference between revisions

From KAVAN RC Wiki
(Importing a new version from external source)
 
(Importing a new version from external source)
 
(No difference)

Latest revision as of 11:32, 26 May 2025

Message definition (KAVAN Long sticks - Installation manual)
=== Installation ===
# Disassemble the original stick you want to replace.
## Remove the handle using a 2mm hex key.
## Remove the stick from the gimbal using a 5mm wrench.
# Remove the core from the new stick and apply a threadlocker.
# Install the new core onto the gimbal.
# Remove the battery compartment cover and the battery.
# Unscrew the rear case of the radio with a 2.5mm hex key. '''Caution:''' Be careful not to damage the antenna wires.
# Thread the stick cables through the gimbal.
# Secure the tuning stick on the gimbal using a 1.5mm hex key.
# Solder the wires of the stick according to the schematic below using a micro soldering iron.
# Bind the wires together with a zip tie. Make sure the gimbal moves freely and cut the excess zip tie.
# Double-check that the gimbal and switches move freely.
# Put the rear cover back on and tighten the 4 screws with a 2.5mm hex key.
# Insert and plug in the battery, and put on the battery compartment cover.
# In the ETHOS interface, create and set up the new switches.

Installation

  1. Disassemble the original stick you want to replace.
    1. Remove the handle using a 2mm hex key.
    2. Remove the stick from the gimbal using a 5mm wrench.
  2. Remove the core from the new stick and apply a threadlocker.
  3. Install the new core onto the gimbal.
  4. Remove the battery compartment cover and the battery.
  5. Unscrew the rear case of the radio with a 2.5mm hex key. Caution: Be careful not to damage the antenna wires.
  6. Thread the stick cables through the gimbal.
  7. Secure the tuning stick on the gimbal using a 1.5mm hex key.
  8. Solder the wires of the stick according to the schematic below using a micro soldering iron.
  9. Bind the wires together with a zip tie. Make sure the gimbal moves freely and cut the excess zip tie.
  10. Double-check that the gimbal and switches move freely.
  11. Put the rear cover back on and tighten the 4 screws with a 2.5mm hex key.
  12. Insert and plug in the battery, and put on the battery compartment cover.
  13. In the ETHOS interface, create and set up the new switches.
Retrieved from "https://wiki.kavanrc.com/index.php?title=Translations:KAVAN_Long_sticks_-_Installation_manual/9/en&oldid=32926"