Translations:KAVAN V20 + ETHOS™ - User manual/977/en: Difference between revisions

Latest revision as of 10:30, 19 March 2024

Message definition (KAVAN V20 + ETHOS™ - User manual)

* '''No signal''': when signal is lost, the receiver does not send a control signal to the rates on any channel. To use this type, select it from the menu and wait 9 seconds for the Fail-safe setting change to take effect.
* '''Hold''': the receiver maintains the rates as they were before the signal was lost. To use this type, select it from the menu and wait 9 seconds for the Fail-safe setting change to take effect.
* '''Custom''': the receiver keeps the rate value on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to „Custom“. Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.

No signal: when signal is lost, the receiver does not send a control signal to the rates on any channel. To use this type, select it from the menu and wait 9 seconds for the Fail-safe setting change to take effect.
Hold: the receiver maintains the rates as they were before the signal was lost. To use this type, select it from the menu and wait 9 seconds for the Fail-safe setting change to take effect.
Custom: the receiver keeps the rate value on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to „Custom“. Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.

@@ Line 1: / Line 1: @@
-* '''Bez signálu''': při ztrátě signálu přijímač neodesílá ovládací signál výchylkám na žádném kanálu. Chcete-li použít tento typ, vyberte jej v nabídce a počkejte 9 sekund, než se projeví změna nastavení Fail-safe.
+* '''No signal''': when signal is lost, the receiver does not send a control signal to the rates on any channel. To use this type, select it from the menu and wait 9 seconds for the Fail-safe setting change to take effect.
-* '''Držet''': přijímač udržuje výchylky takové, jaké byly před ztrátou signálu. Chcete-li použít tento typ, vyberte jej v nabídce a počkejte 9 sekund, než se projeví změna nastavení Fail-safe.
+* '''Hold''': the receiver maintains the rates as they were before the signal was lost. To use this type, select it from the menu and wait 9 seconds for the Fail-safe setting change to take effect.
-* '''Vlastní''': přijímač udržuje hodnotu výchylek na všech kanálech takovou, jakou předem zvolíte. Zvolte nabídku nastavení Fail-safe. Přepněte z Odpojit/Držet/Nenastaveno na „Vlastní“. Zvolte kanál, u kterého chcete nastavit nouzové výchylky a potvrďte volbu. Poté nastavte výchylky na každém požadovaném kanálu a potvrďte volbu. Počkejte 9 sekund, než se projeví změna nastavení Fail-safe.
+* '''Custom''': the receiver keeps the rate value on all channels as you preselect it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not Set to „Custom“. Select the channel for which you want to set fail-safe rates and confirm the selection. Then set the rates on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.