Translations:KAVAN C100 Duo - Instruction manual/17/en

Advanced settings

Under the standby interface, long press the CH1 and CH2 button at the same time to enter the advanced setting menu.

Dual task

Select this setting, the charger will charge/discharge/store to the two channel batteries with the same parameters at the same time. Connect the charger with the power supply and power on; select

this setting on the advanced setting menu to set the task parameters.

Note: Both batteries have to be connected to the CH1 and CH2 outputs before you try to launch the DualTask mode.

Parallel task

Select this setting; it could output Max Power to one battery. Find a power splitter or 1/2 power cord, one end connect with the battery, and the other two ends connect with the battery output port. The battery balance port could connect with any of the charger‘s balance port. Connect the charger with the power supply and power on, and connect your battery as required, select this setting on the advanced setting menu to set the task parameters.

DC power CH1

The charger CH1 is equivalent to a DC power supply when selecting this function, with output voltage adjustable from 2 to 30V, and current adjustable from 1.0 to 5.0A.

System setting menu

Under the advanced setting menu, select the system setting into the system setting menu as follows:

Lowest input voltage: 10~31V

All tasks in operation will be stopped at once and hint warning of low voltage, when the input voltage is lower than the input voltage as set up. It will protect the battery from being discharged when using battery pack as power supply.

Max. input power: 100~1100W

If the input power is smaller than the max. working power (1000W), please set up the parameter as the actual output power as max input, to protect the input power and enable the charger to work stable.

Backlight

Adjust the backlight intensity

Volume

Adjust the sound signal volume

Completion tone

Select the completion tone.

USB charge

When this item is set to „Off“, and TYPE-C is the upgrade port. When this item is set to „On“, TYPE-C acts as a USB charging port and outputs 5V/2A power.

Split screen

There are 3 options of 60 seconds, 30 seconds and OFF for automatic split screen setting. You can choose to switch the display of the main interface from the single-channel parameter interface to Dual channel (split screen) parameter interface. You can also select „Off“ to turn off the automatic split screen function.

Language

Select the desired language of the menu.

Theme

Select the display style.

Keep trickle

After charging is complete, choose whether to continue trickle charging.
The trickle charge function is enabled to maintain the lithium battery voltage in a fully charged state; this function is enabled by default.

Self-test

Perform self-test of the charger.

Calibration

The input voltage, output voltage and balance voltage of the charger can be calibrated with this task.

System info

Hardware/firmware version information.