Translations:KAVAN Dingo A3 glider kit 796mm - Instruction manual/29/en

Only apply the dope in a dry and well ventilated area at room temperature (over 20°C; low temperature/high humidity may cause "fogging" of some dopes turning them milky white instead of clear. If that happens you can usually cure it by taking the model to a dry and warm place and applying just the fresh thinner with a brush to the "fogged" part). Apply 3 to 5 coats of thinned dope to the entire model (use the top gloss dope for the fuselage and the last coat for the wing and horizontal tailplane). Lightly sand all doped surfaces with fine sandpaper between each coat. Apply the colour tissue trim to the fuselage before the last coat of dope (use the top gloss dope for the final coat). The stickers are to be applied only after the final coat!