Translations:KAVAN AP09A - Instruction Manual/64/en: Difference between revisions

Revision as of 07:48, 7 August 2025

8. If restarting the engine while warm, simply connect the power to the glow plug and turn the engine once. If the engine is very hot, it may need to be re-primed. Only commence in re-priming the engine if it does not fire. A too hot engine can sometimes burn the prime prematurely. If the engine is that hot, let it cool for a few minutes before restarting. You may also wish to re-evaluate your needle valve setting, because the mixture may be set too lean.

Revision as of 11:23, 6 August 2025 view source FuzzyBot (talk \| contribs) 14,395 edits Importing a new version from external source		Revision as of 07:48, 7 August 2025 view source FuzzyBot (talk \| contribs) 14,395 edits Importing a new version from external source Newer edit →
Line 1:		Line 1:
	8. ~~After 20 to 40 seconds~~, ~~disconnect~~ the ~~battery~~ to the glow plug~~. Then slowly~~ turn the ~~needle valve to „lean“ the mixture and increase rpms~~. ~~Over adjusting or abrupt adjustments will „over lean“~~ the engine ~~and cause~~ it to ~~stall and possibly to damage~~ the engine. If ~~this is the first or an early run for~~ the engine, ~~refer~~ to ~~the Break~~-~~In section of~~ the ~~manual before continuing~~.		8. If restarting the engine while warm, simply connect the power to the glow plug and turn the engine once. If the engine is very hot, it may need to be re-primed. Only commence in re-priming the engine if it does not fire. A too hot engine can sometimes burn the prime prematurely. If the engine is that hot, let it cool for a few minutes before restarting. You may also wish to re-evaluate your needle valve setting, because the mixture may be set too lean.