Translations:KAVAN Dingo A3 glider kit 796mm - Instruction manual/21/en

Round the leading and trailing edges of the rudder 30. Use the tip of a pointy modeller's knife to cut slots for the brass tin rudder hinges 29 into the fin 28 and rudder 30. Cyano the hinges into the rudder and then into the fin leaving a slight gap between the fin and rudder. Glue the complete fin and rudder assembly between the tail boom sticks. The bottom edges matching. Glue the beech wing hold-down dowel 35 into the fuselage. Drill the hole for the horizontal tailplane hold-down dowel 34 (bamboo ø2.5×25 mm) using 2.5 mm drill bit (10 mm deep) and glue it in place. Make the front horizontal tailplane seat. Glue the spruce stick (3x5×25 mm) 27 to the Plywood plate (1 mm - 25×15 mm) 26. Glue it to the tail boom and into the notch in the fin. Lay the horizontal tailplane down on the seat in order to check the tailplane was square to the fuselage sides (when looking from the nose to the tail) and also square to the longitudinal axis of the fuselage (when looking from above). Cut 1.5 mm notches for the rubber band in the spruce stick 27 (refer to Det. J–J) using fine file, jigsaw or razor saw.