Translations:KAVAN Smart PRO Opto ESCs - Instruction manual/182/en

PowerBox Telemetry

From version 1.09, the KAVAN Smart PRO controller can recognise the PowerBox P²Bus telemetry protocol. Connect the telemetry cable (red connector) to the P²Bus port on the receiver. The transmitter will locate the connected sensors when the receiver is switched on. The controller telemetry should then be available within 2.5 seconds. You can now assign telemetry values to any widgets and alarms on the transmitter's screen. The available telemetry is similar to the Duplex EX telemetry (see above). Configuring the controller via the PowerBox transmitter is not available at this time.