Translations:KAVAN Smart PRO Opto ESCs - Instruction manual/190/en

Safety information

• Always use the KAVAN Smart PRO controller in a dry environment and within the limits of the equipment specified in this manual. Never expose the device to excessive heat or cold outside the operating range.
• Ensure sufficient airflow to prevent the controller from overheating.
• Never exceed the maximum allowed operating voltage of the controller or the motor.
• Do not increase the cable length between the controller and the motor. If you need to extend the wires between the ESC and the battery to more than 30 cm (total), solder several high-capacity Low-ESR capacitors (220–470 µF) in parallel to the power wires as close to the ESC as possible. For each centimetre over the specified length of the cables, add 1 µF of capacitance per 1 cm of length for each ampere of current passing through. At 10 cm over the limit for 100A current, connect 1000 µF capacitors.
• Always use high-quality connectors in good condition. If there are any visible signs of wear, replace them.
• Always remove the propeller before making any changes to the drive setup.
• Never disconnect the controller from the battery while the motor is revving.
• Do not remove the packaging and heat sink from the unit or attempt to make any changes or adjustments. Doing so may result in irreversible damage and denial of any warranty claims.
• Always check the polarity of the connections. Never reverse the polarity - this could lead to irreversible damage.

Firmware updates

Firmware updates for KAVAN Smart PRO controllers are uploaded from a computer via USB. The required software and files are available at www.mavsense.com.