KAVAN Smart PRO telemetry Lua applications - Setup manual

Introduction

The Smart PRO speed controllers and telemetry and power management units seamlessly communicate with your ETHOS radio.

Setting up

The method consists of 3 phases:

Preparing the Lua script
Unit wiring
Setting up and operating the telemetry

A. Preparing the Lua script

Download files for Lua scripts - controller setup application

Download link from KAVAN website

Extract the "scripts.zip"
Select the folder with the required script, e.g. "smart_pro" for the KAVAN Smart PRO series of controllers
Switch on the KAVAN V20 transmitter
Connect to a PC using the USB-C connector to the USB-A 2.0 port
A pop-up window will appear on the transmitter, here select "ETHOS Suite"
Then upload the "smart_pro" folder to the transmitter's memory RADIO:/scripts
Disconnect the transmitter from the PC and turn off the transmitter.

B. Unit wiring

C. Setting up and operating the telemetry

Telemetry setup

Assuming that the registration and pairing of the receiver is correct, check or enable the following options: In Model Settings -> RF System Select the receiver to which the KAVAN Smart PRO controller is connected Select the "Options" of the receiver for proper functionality, telemetry must be enabled and the telemetry port must be set as "F.Port", see Fig.

Putting telemetry into operation

In the section Model settings -> Telemetry Select to search for new sensors The telemetry data of the controller and receiver should already be displayed in the list below.

3) Application settings In the System -> KAVAN Smart section Description of settings, statistics, etc. Change here, there will be a new screen with the correct sensors