| Trouble
|
Possible reason
|
Solution
|
| After powering on, the motor does not work and no sound is emitted.
|
The connection between the battery pack and ESC is not correct.
|
Check the power connection. Replace the connector.
|
| After powering on, the motor does not work, such an alert tone is emitted: "beep–beep–, beep–beep–, beep–beep–" (Every "beep–beep–" has a time interval of about 1 second).
|
Input voltage is abnormal, too high or too low.
|
Check the voltage of the battery pack.
|
| After powering on, the motor does not work, such an alert tone is emitted: "beep–, beep–, beep–" (Every "beep–" has a time interval of about 2 seconds).
|
Throttle signal is irregular.
|
Check the receiver and transmitter. Check the cable of the throttle channel.
|
| After powering on, the motor does not work, such an alert tone is emitted: "beep–, beep–, beep–" (Every "beep–" has a time interval of about 0.25 seconds).
|
The throttle stick is not in the bottom (lowest) position.
|
Move the throttle stick to the bottom position.
|
| After powering on, the motor does not work, a special tone "56712" is emitted after a 2-beep tone (beep–beep–).
|
The direction of the throttle channel is reversed, so the ESC has entered the program mode.
|
Set the direction of the throttle channel correctly.
|
| The motor runs in the opposite direction.
|
The direction. The connection between ESC and the motor needs to be changed.
|
Swap any two wire connections between ESC and motor.
|
