Translations:KAVAN Long sticks - Installation manual/9/en

Installation

1. Disassemble the original stick you want to replace.
   1. Remove the handle using a 2mm hex key.
   2. Remove the stick from the gimbal using a 5mm wrench.
2. Remove the core from the new stick and apply a threadlocker.
3. Install the new core onto the gimbal.
4. Remove the battery compartment cover and the battery.
5. Unscrew the rear case of the radio with a 2.5mm hex key. Caution: Be careful not to damage the antenna wires.
6. Thread the stick cables through the gimbal.
7. Secure the tuning stick on the gimbal using a 1.5mm hex key.
8. Solder the wires of the stick according to the schematic below using a micro soldering iron.
9. Bind the wires together with a zip tie. Make sure the gimbal moves freely and cut the excess zip tie.
10. Double-check that the gimbal and switches move freely.
11. Put the rear cover back on and tighten the 4 screws with a 2.5mm hex key.
12. Insert and plug in the battery, and put on the battery compartment cover.
13. In the ETHOS interface, create and set up the new switches.