Translations:KAVAN AP06A - Instruction Manual/37/en

Carburettor Installation

The carburettor is held in place using two M2x3mm machine screws provided. Slide the base of the carburettor into the crankcase, being careful to keep the carburettor perpendicular to the front of the engine. With your thumb, push down on the carburettor firmly so the base of the carburettor seats completely into the crankcase and the carburettor O-ring seals the gap between the two. While holding the carburettor in place, thread the two machine screws into the carburettor base and tighten them using a flat blade screwdriver. Tighten the screws until they are snug. Do not over tighten them.