Translations:KAVAN GRT-10 Brushed - Instruction manual/21/en

Fail-safe

This function dictates what the receiver will do in the event that it loses signal from the transmitter (the receiver LED starts blinking); it presets the emergency servo/ESC position. For electric cars we strongly recommend setting the fail-safe for both steering and throttle to neutral (you car will stop once the signal is lost). For nitro cars the throttle fail-safe should make the brake engage. Function Setting:

1. Turn on the transmitter and make sure it is connected to the receiver.
2. Hold the steering wheel and throttle trigger at the desired fail-safe position.
3. Press and hold the BIND button for 3 seconds; the G.LED starts to flash for 2 seconds, indicating that the settings are successful.

Note: The fail-safe function has not been set at the factory by default – you should set it accordingly during the initial set-up of your model. If no failsafe setting has been set, then the receiver will maintain the output of the last signal when the signal is lost.

Note: Binding erases the previously set fail-safe stored in the receiver - you have to set the fail-safe again.

Beginner mode

Beginner mode is designed for the people who are new to the hobby. In this mode the throttle has been limited to 50 percent.