Translations:KAVAN GRT-10 Brushed - Instruction manual/22/en

Function setting:

To switch between beginner and normal modes, press and hold the CH4 button while turning the steering wheel completely counter clockwise as far as it can, and at the same time, power on the transmitter.

Note: By default, the system is set to normal mode. If the system has set to beginner mode, the G.LED will be in a state of two-time flashing and on off, and keep the state for 3 seconds during power on.

Preparing your car for the first run

Turning on the power

Remember: ALWAYS turn on the transmitter first and only then the receiver.

1. Turn on transmitter first. Set both the steering and throttle trims to the centre (double blink); set the steering dual rates to max. (keep pushing the ST.D/R+ button until the G-LED stop blinking).
2. Depending on the power pack you are using (NiMH or LiPo) set this type on the ESC; check the running mode is set to Forward/Brake/Reverse (refer to the ESC manual in the appendix).
3. Connect the power pack to the speed controller in your car. Turn on the ESC switch. The receiver LED indicator should glow continuously red. If the receiver LED is flashing or does not light at all, the transmitter and receiver have not been paired. Refer to the „Binding the Transmitter and Receiver“ section.
4. The ESC gives the ready signal (refer to the „ESC Throttle Range Calibration“ section). The car is ready for the first test.