Translations:KAVAN GRT-10 Brushed - Instruction manual/23/en

Transmitter control check and trim setup

1. Turn the steering wheel to the left (counter clockwise); the front wheels of your car have to turn left. If the wheels turn right, flip the ST.REV reverse switch on the transmitter.
2. With the steering wheel and trim in the centre the front wheels must point straight forward. If wheels point left, push the steering trim to the right. If wheels point right, push the steering trim to the left. (The front wheels actually have a slight toe-in or toe-out.)
3. Pull the throttle trigger slightly just to see the wheels turning – your car has to go forward. Push (twice) the throttle trigger forward – your car has to go back. With the throttle trigger and trim in the centre the wheels may not spin. If this is not the case, refer to the „ESC Throttle Range Calibration“ section.