Translations:KAVAN R8 - User manual/45/en: Difference between revisions

From KAVAN RC Wiki
VisualWikitext
(Importing a new version from external source)
 
(Importing a new version from external source)
 
Line 1: Line 1:
'''Custom:''' the receiver maintains the deflection value on all channels as you pre-select it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not set to "Custom". Select the channel for which you want to set fail-safe deflections and confirm the selection. Then set the deflections on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
'''Custom:''' The receiver maintains the deflection value on all channels as you pre-select it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not set to "Custom". Select the channel for which you want to set fail-safe deflections and confirm the selection. Then set the deflections on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
'''Note:''' If fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If fail-safe is disabled on the RF side of the module, the receiver will go into default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode because the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.
{{Note|type=info|'''Note:''' If Fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If Fail-safe is disabled on the RF side of the module, the receiver will go into default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode because the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.}}

Latest revision as of 11:35, 7 May 2024

Message definition (KAVAN R8 - User manual)
'''Custom:''' The receiver maintains the deflection value on all channels as you pre-select it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not set to "Custom". Select the channel for which you want to set fail-safe deflections and confirm the selection. Then set the deflections on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.
{{Note|type=info|'''Note:''' If Fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If Fail-safe is disabled on the RF side of the module, the receiver will go into default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode because the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.}}

Custom: The receiver maintains the deflection value on all channels as you pre-select it. Select the Fail-safe setting menu. Switch from Disconnect/Hold/Not set to "Custom". Select the channel for which you want to set fail-safe deflections and confirm the selection. Then set the deflections on each desired channel and confirm the selection. Wait 9 seconds for the Fail-safe setting change to take effect.

Note: If Fail-safe is not set, the model will always operate with the last functional state of the channels before signal loss. This could cause potential damage. If Fail-safe is disabled on the RF side of the module, the receiver will go into default Hold mode. Do not set the Fail-safe mode for the SBUS port to No Signal mode because the signal would be continuously transmitted, set the SBUS port to Hold or Custom mode.
Retrieved from "https://wiki.kavanrc.com/w/index.php?title=Translations:KAVAN_R8_-_User_manual/45/en&oldid=11408"