KAVAN V20 - Změna módu
Introduction
Změnit mód vašeho vysílače je snadné a rychlé, pokud postupujete správně. Postupujte podle kroků níže pokud chcete změnit mód, nebo pokud chcete nastavit vlastnosti pák.
Description
- Horizontal centring tension spring - right gimbal
- Ratcheting adjustment screw - right gimbal
- Brake/resistance adjustment screw - right gimbal
- Centring spring lock
- Vertical centring tension spring - right gimbal
- Ratcheting adjustment screw - left gimbal
- Brake/resistance adjustment screw - left gimbal
- Vertical centring tension spring - left gimbal
- Hole for the centring spring lock
- Horizontal centring tension spring - left gimbal
Steps
- Remove the battery compartment cover.
- Unplug and remove the battery from the battery compartment.
- Holding the handle in your hands carefully remove the rear cover. Be careful not to pull the antennas.
- Rotate and flip the rear cover to make some space.
- Unscrew the centring spring lock from the current throttle stick.
- On the current throttle side tighten the vertical tension spring counterclockwise so the stick centres.
- On the opposite side loosen the vertical tension spring clockwise.
- Lift the centring arm a little and insert and screw in the centring spring lock on the new throttle stick side.
- Set the feedback of both gimbals to your preference via the steps below.
- Put the rear cover back in place.
- Screw in the 4 screws on the rear cover.
- Plug in and insert the transmitter battery in the battery tray.
- Put the battery tray cover on.
Setting the gimbal feedback
- Screws on the inner side of the strip (2, 6) set the gimbal tension.
- Screws on the outer side of the strip (3, 7) set the ratcheting.