Translations:KAVAN Beta 1400 Kit - Instruction manual/36/en

• Locate the right fuselage half. You will find the KAVAN GO-09-sized bay for the rudder servo in the rear part of the cockpit compartment.
• Prepare the one-sided arm supplied with the KAVAN GO-09 (or cut a two-side arm to one-side arm). Turn on your transmitter, set the rudder stick and trim to the centre (neutral). Connect the rudder servo to the appropriate receiver output (CH4 with the T8FB), plug the ESC’s cable to the throttle channel (CH3 with the T8FB) and connect the flight pack. Insert the Z-bend on the end of the elevator push rod into the middle hole in the servo arm (ca 10 mm from the centre of the arm). Now insert the servo into the servo bay, so the servo output shaft is closer to the nose.
• Now attach the servo arm on the output shaft of the servo - it should be square to the side of the servo case as much as possible. Secure the servo arm with the screw supplied with the servo. Glue the servo with drops of hot melt glue or MS polymer glue over the servo lugs. You can use a medium CA as well, but the hot melt glue or MS polymer glue could be easily removed without damage to your model if you ever needed to get the servo out.