Translations:KAVAN Beta 1400 Kit - Instruction manual/43/en

• Check the correct polarity of the canopy lock magnets and cyano them into the respective recess on the rear side of the cockpit and canopy. Cover it with a piece of clear sticky tape in the end.
• Cyano (alternatively you can use a thin double-sided sticky tape or contact cement) the plastic reinforcement to the bottom side of the fuselage.
• After the motor (do not forget to apply a blue thread locker to the setting screws) and ESC have been installed, secure the plastic servo cover into the fuselage using drops of hot melt glue, small pieces of hook and loop tape or small magnets (not supplied in the kit). The point is securing the cover in place - yet making it removable to access the servos if needed.
• Install the propeller yoke and secure it with two M3×6 mm setting screws (do not forget to apply a blue thread locker to the screws). Finally, install the spinner using two M2×8 mm screws. Be sure the propeller rotates freely. No matter what, the propeller blades may not graze the fuselage. (Fig. 2)