Translations:KAVAN Cumul DLG kit 1096mm - Instruction manual/17/en

• Trial fit the parts of the horizontal stabilizer, elevator, fin and rudder – no glue yet! Sand as necessary to obtain a perfect fit. (Fig. 1+2)
• Roughen the surface of the 3×0.5 mm R3 carbon spar using no.120 sandpaper and glue it with medium CA to the trailing edge of the fin R1.
• Glue the T3 reinforcement plate into the horizontal stabilizer T1. Once the glue has cured, sand it flush with the stabilizer.
• Sand the entire surface of the horizontal stabilizer, elevator, fin and rudder with no.120–150 sandpaper; round the outer edges.
• Put the tail surfaces aside for now. They will be finished after the tailplane seat is installed to the tail boom.