| Troubles
|
Warning tones
|
Causes
|
Solutions
|
| After connecting the battery the motor doesn't work, doesn't beep.
|
-
|
Incorrect wiring or loose connection between the ESC and battery.
|
Check the wiring, check the connector and change it for a new one, if needed.
|
| After connecting the battery the motor doesn't work, and beeps.
|
"BB, BB, BB,....."
|
The input voltage was beyond the operation g voltage range of the ESC.
|
Adjust the power-on voltage and ensure it’s in the operating voltage range of the ESC.
|
| After connecting the battery the motor doesn't work, and beeps.
|
"B–, B–, B–, B–....."
|
The ESC didn’t receive any throttle signal from the receiver.
|
Check if the transmitter and receiver are well paired, or if any poor connection exists between the ESC and receiver.
|
| After connecting the battery the motor doesn't work, and beeps.
|
"B, B, B, B....."
|
The throttle stick has not been moved to the bottom position.
|
Move the throttle stick to the bottom position and calibrate the throttle range.
|
| After the throttle calibration the motor doesn't work, and beeps.
|
"B, B, B, B....."
|
The throttle range you set was too narrow.
|
Re-calibrate the throttle range.
|
| The ESC output suddenly reduced to 60 % during the flight, the motor beeps after the flight ends and the battery is still connected.
|
"BB, BB, BB....."
|
The ESC thermal protection has been activated.
|
Improve the heat-dissipating condition (i.e. add a cooling fan) or reduce the ESC load.
|
| The ESC output suddenly reduced to 60 % during the flight, the motor beeps after the flight ends and the battery is still connected.
|
"BBB, BBB, BBB....."
|
The low-voltage cut-off protection has been activated.
|
Change another pack. Lower down the cut-off voltage or disable the LVC protection (we do not recommend this).
|
