Translations:KAVAN Der mini Falke 710mm - Instruction manual/14/en

From KAVAN RC Wiki
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
  1. Carefully sand the entire surface of the wing halves no. 1 and no. 2.
  2. Glue together the wing assembly jig following the picture in the centre of the building plan.
  3. Glue the wing halves together on a flat building board protected with a sheet of thin plastic film preventing the wing from sticking to the board. Pin down one of the wing halves. Then attach the other one supported by the wing assembly jig. Let the glue cure thoroughly.
  4. Carefully sand the entire surface of the wing panels, no. 3. Glue them one by one to the wing centre section using the wing assembly jig.
  5. Once the glue has cured, carefully sand the entire surface of the wing. Glue the wing reinforcement plate no. 4 in place.
  6. Apply a light coat of thinned protective dope to the entire wing. When dry, lightly sand all doped surfaces with the fine sandpaper. Repeat twice more. Sand lightly once every coat has dried.
Retrieved from "https://wiki.kavanrc.com/w/index.php?title=Translations:KAVAN_Der_mini_Falke_710mm_-_Instruction_manual/14/en&oldid=18543"