Translations:KAVAN TARA A1 (F1H) - Instruction manual/21/en

From KAVAN RC Wiki
Revision as of 10:00, 11 September 2024 by FuzzyBot (talk | contribs) (FuzzyBot moved page Translations:TARA Glider Kit A1 (F1H) - Instruction manual/21/en to Translations:KAVAN TARA A1 (F1H) - Instruction manual/21/en without leaving a redirect: Part of translatable page "TARA Glider Kit A1 (F1H) - Instruction manual")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Horizontal tailplane

The horizontal tailplane is to be built directly on the plan protected with a clear plastic film in similar manner as the wing. Pin down the spruce trailing edge (3×5×405 mm) 11 overlapping on both two ends. Glue the balsa centre plate (3 mm – 30×80 mm) 13 to the trailing edge 11. Glue the spruce leading edges (3×5×197 mm) 10 to the centre plate and pin them down overlapping on both two ends. Cut to size and glue in place the diagonal ribs 12 made of 3×5 mm balsa stick. Start with the outer diagonal ribs first. Then proceed towards the centre of the horizontal tailplane.

Retrieved from "https://wiki.kavanrc.com/w/index.php?title=Translations:KAVAN_TARA_A1_(F1H)_-_Instruction_manual/21/en&oldid=18849"