Translations:KAVAN Robin Glider Kit 495mm - Instruction manual/19/en

Drill a 4 or 5 mm access hole into the additional ballast compartment in the fuselage (refer to the building plan). Support the wing of the model with your fingertips in the centre of gravity position (the point marked on the fuselage plan). The fuselage should be level - if the nose pitches up, put in as much additional ballast (not supplied in the kit) as necessary (you can use pellets, small screws etc.). Once satisfied, seal the hole with a strip of clear sticky tape. Finally, glue the anti-slip strips (27) made of fine sandpaper allowing a secure grip of your model when you are launching it.