Translations:KAVAN R10 - User manual/34/en

From KAVAN RC Wiki
Revision as of 09:39, 13 December 2024 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Move to the [SRX Cali] tool and calibrate the gyroscope sensor

  1. The gyroscope of the device (6 surfaces) must be calibrated before mounting into the model. Place the device on a flat surface and follow the instructions below to calibrate the gyroscope.
  2. Make sure the stabilisation device is lying on the surface with the logo/label facing upwards. Move to the radio and enter the [SRX Cali] tool and select "click to confirm". At this moment, the yellow LED light will flash. After it turns off, follow the prompts to calibrate the sensor.
  3. Complete the calibration of all the device surfaces. Ensure the value of each axis (X, Y, Z, Mod) is about 1.000 while placing the device in the corresponding direction. The deviation should be within ±0.1.
  4. The calibration is completed if all the steps above are done.
Retrieved from "https://wiki.kavanrc.com/w/index.php?title=Translations:KAVAN_R10_-_User_manual/34/en&oldid=28608"