Translations:KAVAN Mirai glider kit 1995mm - Instruction manual/21/en

Tail surfaces - continued

• Insert the R10 fibreglass fin fixing plate into the opening in the fin. Do not glue yet! (Fig. 16)
• Slide the horizontal stabilizer and fin onto the R11 carbon rods. Screw in the M3 nylon bolt through the hole in the tail boom, R10 plate into the F16 nut. Align the R10 late flush with the left side of the fin. Push the fin to the stabilizer and fuselage and tack glue the R10 plate to the fin with a couple of CA drops. (Fig. 17) (Fig. 18)
• Remove the fin, cyano the R10 plate thoroughly to the fin; fill the recess on the right side using the R14 1.5 mm balsa filler. Sand the entire fin smooth. (Fig. 19)
• The rudder and elevator horns R16 and T10 as well as the R8 skid will be glued in later after the tail surfaces are covered.