Translations:KAVAN Mirai glider kit 1995mm - Instruction manual/28/en

The rudder and elevator servos are to be installed into their servo tray F23 under the F16 hatch (glider) or into the E3 servo tray under the wing (electric version). Cyano the pushrod tubes into the fuselage formers; you can use the supplied fibreglass pushrod holders (Bag 1) to secure the ends of the tubes.
Solder the M2 brass threaded couplers to one end of the piano wire pushrods and attach the M2 ball links.
Alternatively you can use a closed loop of a Kevlar thread (not supplied in the kit) to hook the rudder – it might save some weight. In that case, you will need to install just one pushrod for the elevator.
Fit the tail surfaces to the fuselage; insert the control horns into the rudder and elevator – do not glue yet. Set the servos in a neutral position with your radio on and mark the correct length of the push rod wires. Make a "Z" bend on the end of the pushrod and fit it to the rudder and elevator horns. Check once again and only then cyano the control horns in place. Do not forget to glue the end of the elevator push rod tube to the fuselage.