Translations:KAVAN Alpha 1500 V2 - Instruction manual/167/en

1. Locate the steel wire wing joiner (note the "V" shape ensuring the correct wing dihedral) with the plastic adapter and slide both wing halves onto the joiner.
2. Secure the wing halves using the wing joiner plate.
3. Use the supplied Y-cables to connect the aileron servos and LED light cables:
   A. A radio featuring only one aileron channel (like the T8FB supplied in the RTF set): Connect both two aileron servos (connector label "AILE") to one Y-cable and both two LED light cables (labelled "LED") to another Y-cable. The aileron Y-cable is to be connected to the aileron channel of your receiver (CH1 in the case of T8FB). The LED light Y-cable could be connected to any unused channel of your receiver (the LEDs are just powered by the receiver, they are not remote-controlled by the radio).
   B: A radio featuring 2 independent aileron servo channels: Connect one aileron servo and one LED light to each Y-cable. Connect the Y-cables to the respective aileron channels of your receiver (typically, CH1 and CH5 or CH6 – it depends on the transmitter and its setting – please refer to the instruction manual of your radio).
4. Secure the wing using two 2.5×15 mm screws to the fuselage.