Slide both wing halves onto the metal wing joiner.
Secure the wing halves using the wing joiner plate.
Use the supplied Y-cables to connect the aileron servos and LED light cables:
A radio featuring only one aileron channel: Connect both two aileron servos (connector label “AILE”) to one Y-cable and both two LED light cables (labelled “LED”) to another Y-cable. The aileron Y-cable is to be connected to the aileron channel of your receiver (typically CH1 with many radios); the LED light Y-cable could be connected to any unused channel of your receiver (the LEDs are just powered by the receiver; they are not remote controlled by the radio).
A radio featuring 2 independent aileron servo channels: Connect one aileron servo and one LED light to each Y-cable; connect the Y-cables to the respective aileron channels of your receiver (typically, CH1 and CH5 or CH6 – it depends on the transmitter and its setting – please refer to the instruction manual of your radio).
