Translations:KAVAN Alpha V2 1500mm - Instruction manual/59/en

6. Control Surface Throws

If you carefully followed the instruction in the previous sections of this manual, the correct default control surface throws has been set automatically. The control throws are set by the ratio between the length of the servo arm and the control surface throw - the actual throws set this way are listed in the column “Normal Rate” in the table below. (The throws are always measured in the widest point of the particular control surface.) It is always better to try to reach the requested throws mechanically, adjusting the arm/horn length ratio - even if you have got a fancy computer radio. If you got such a transmitter you can use the function “Dual Rate” (D/R) to get even more forgiving set-up - please refer to the “Low Rate” column. You can also do it mechanicaly - simply move the push rod Z-bends on the servo arms closer to the centre.