You can find moulded servo bays in both two wing halves that fit KAVAN GO-09 servos or similar. Set the aileron servos to neutral with your radio on (in the same way as you did with the elevator and rudder servos). Attach the one-sided servo arms so the arms are square to the side of the servo case as much as possible. Please note you must obtain a mirror image pair - simply lay both servos down on the table, the output shaft pointing towards each other and both the servo sides with servo cables pointing in the same direction. Now attach the servo arms - square to the servo case side, same on both two servos. Check the operation of aileron servos and secure the arms with screws supplied with the servos.
Insert the servos into the servo bays and secure them with drops of hot melt glue or MS polymer glue over the servo lugs. Connect the supplied extension cables to the aileron servos. Deploy the servo cable (with the connector put neatly into the bay in the wing) in the aileron servo cable groove. The end of the cable should stick out of the wing by 10 cm (4") to allow inserting the cable into the fuselage. Apply a strip of clear sticky tape over the aileron servo cable grooves.
