Translations:KAVAN Dingo A3 glider kit 796mm - Instruction manual/15/en

Glue the wing joiners 8 to both sides of the main spar 7 and into the notch in the root rib 4 of one wing half matching the upper edge of the main spar. Apply a generous amount of glue to both root ribs, wing joiners 8, leading and trailing edges, and attach the wing halves together. Lay one of the wing halves down on the building board. Secure it with a couple of magazines wrapped in a plastic bag serving as a weight. Align the other half so the tip of it was 150 mm above the building board (you can use a couple of books or a wooden block) and the trailing and leading edges were in one straight line. Let the glue cure thoroughly. Once cured, carefully sand the joint and the entire wing using sanding blocks with a coarse and then fine sandpaper to smooth any rough areas. The wing is ready to covering now.