Translations:KAVAN GRT-10 Brushed - Instruction manual/25/en

Fail safe setup

The receiver has a built in failsafe. The failsafe will automatically go to a pre-set position if the receiver lose radio signal from the transmitter or suffer any interference. If properly set up, the fail safe cuts the throttle to neutral so the car won’t go away under such circumstances.

1. Turn on the transmitter and make sure it is connected to the receiver.
2. Hold the steering wheel and throttle trigger at the desired fail-safe position.
3. Press and hold the BIND button for 3 seconds; the G.LED starts to flash for 2 seconds, indicating that the settings are successful.
4. The fail-safe check: Move the throttle trigger elsewhere from the neutral and turn off your transmitter. The ESC has to cut the throttle and stop the motor.

Note: Any new binding will clear the previous fail-safe setting.