Translations:KAVAN Robin Glider Kit 495mm - Instruction manual/13/en

Joining the wing

Carefully sand and match the left and right wing centre section outer ribs and the wing panel root ribs to get the correct dihedral (refer to the detail B-B). Pin down one of the wing centre sections to the building board covered by a sheet of thin clear plastic film. Apply glue to the other wing centre section root rib and attach it to the wing centre section pinned down. Support the outer rib with 12 mm balsa scrap to set the correct dihedral (det. BB, 12 mm = 2×6 mm balsa scrap 25). Use the remaining no. 4 stick to make 40 mm dihedral jig (26). Apply glue to the wing panel root rib and attach it to the wing centre section pinned down. Support the wing tip with the (26) dihedral jig. Glue the other wing panel in the same way.