Translations:KAVAN SLING Mini 616mm - Instruction manual/32/en
From KAVAN RC Wiki
Please Remember
Always turn the transmitter on first. Only then plug the receiver (Rx) battery to the model.
At the end of your flying session, unplug the Rx battery from the model. Turn the transmitter off last.
You MUST use the included LiPo Charger built in the transmitter ONLY. Failure to do so may result in a fire causing personal injury and/or property damage.
If at any time during the charge process the battery begins to inflate, discontinue charging immediately. Quickly and safely disconnect the battery, then place it in a safe, open area away from flammable materials to observe it for 30–45 minutes. Continuing to charge or discharge a battery that has begun to balloon or swell can result in a fire. A battery that has inflated even a small amount must be removed from service completely.
You must charge the included 3.7V 170 mAh LiPo battery in a safe area away from flammable materials.
Never charge the battery unattended. When charging the battery, you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.
Store the battery at room temperature in a dry area for best results.
When transporting or temporarily storing the battery, the temperature range should be from 20–30°C. Do not store the battery or model in a car or direct sunlight whenever possible. If stored in a hot car, the battery can be damaged or even catch fire.
Do not over-discharge the LiPo flight battery. Discharging the battery too low can cause damage to the battery, resulting in explosion and/or fire.
LiPo cells should not be discharged to below 3 V under load.
