Translations:KAVAN Smart PRO SE6 6ch BUS servo decoder - Instruction manual/11/en
From KAVAN RC Wiki
Actual values - Displays the latest telemetry values (voltage, temperature, system status) including minimums and maximums.
System - Shows the detected serial protocol and its average frame rate.
Fadeouts/FS - Number of frame misses and time spent in fail-safe mode. The number of frame misses increases every time the interval between two consecutive servo frames noticeably exceeds the average period.
Reset Min/Max - Press left+right buttons together to reset all minimums and maximums.
Settings - Basic settings of the sensor.
Language - You can choose the language of the JETIBOX screen.
Period - You can specify a fixed servo output rate (5ms – 30ms), or automatic output rate synchronous to the serial input.
Data Port (6) - Specify a function of the data port – either servo or sensor/terminal can be set.
Fail-safe delay - Set the time that must elapse before entering the fail-safe mode if there is no signal on the serial line.
Ch.1–Ch.6 - Here you can set the properties of each output channel. You can modify the receiver channel assignment to the outputs of the SE6. By pressing both left+right buttons you can change the behaviour if there is no signal on the serial line:
<Hold> (default) - Repeat the last known servo position.
<FS XX> - Set the servo position to a fixed value XX%.
Set fail-safe now - By pressing both left+right buttons the actual servo positions will be stored as fail-safe values.
Service - In this menu you can view the device version and reset it to the default factory configuration.
