Translations:KAVAN Tara A1 (F1H) glider kit 1100mm - Instruction manual/19/en

Trial fit the wing centre section and wing panels – if attached together, the wing panel dihedral must be 100 mm (Det. E). Once satisfied, glue the Plywood wing joiners 42 to the wing centre section main spar 7. Apply a generous amount of glue to wing centre section end ribs, wing panel root ribs and wing joiners 42 and attach the wing panels to the wing centre section. Lay the wing centre section down on the building board. Secure it with a couple of magazines wrapped in a plastic bag serving as a weight. Align the wing panels so their tips were 100 mm above the building board (you can use a couple of books or a wooden block). Let the glue cure thoroughly. Once cured, carefully sand the joints and the entire wing using sanding blocks with a coarse and then fine sandpaper to smooth any rough areas.