Translations:KAVAN Tara A1 (F1H) glider kit 1100mm - Instruction manual/36/en

Wing: Cut four or six pieces of the tissue 10 mm oversized all around the outline (do not forget the upper sheets have to be wider due to the airfoil camber). A skilled builder could cover the entire bottom side of the wing using just one long strip of tissue. The upper side of the wing centre section and wing panels are to be covered by separate strips. Again, start with the bottom side of the win. Apply the glue/dope to the leading and trailing edges and all ribs. Attach the tissue and smooth the edges with finger tips. Cut the tissue all around the outline of the wing leaving it 4–5 mm over size. Bend and glue with thinned white glue or adhesive dope the overlapping tissue around edges of the entire wing. You will have to cut the tissue against the wing panels joints and in short 4–8 mm portions around the wing tip in order to follow the curve of the tip. Cover the upper side of the wing centre section in the same manner (the tissue overlapping over the wing panel root ribs 47). Apply thinned white glue/adhesive dope to the trailing and leading edges, main spar and ribs.