Translations:KAVAN UBEC - Instruction Manual/3/en

Using the UBEC

1. Output voltage: Select the required output voltage by positioning the jumper on the right side of the UBEC.
   
   Caution: Some servos may not be operated at a voltage higher than 5.0 V!
2. Electric-powered model with an OPTO ESC: connect the UBEC directly to the flight battery terminals keeping the correct polarity; the output connector plugs into the „Battery“ socket of your receiver (or any unused servo output).

   

   UBEC - Opto electro

3. IC engine-powered model or a glider: connect the UBEC directly to the receiver battery terminals keeping the correct polarity; the output connector plugs into the „Battery“ socket of your receiver (or any unused servo output).

   

   UBEC - Combustion

4. Electric-powered with an ESC featuring BEC: you have to disable the internal BEC in the ESC first. Remove the pin of the red wire (+) from the ESC servo connector and insulate it with a piece of shrinking tube. The connection of the UBEC is the same as above.

   

   UBEC - BEC electro