Translations:KAVAN Vinx free flight glider 600mm kit - Instruction manual/99/en

90. Remove the covering film from the bottom of the wing centre (applies to the iron-on film covered wing only) and epoxy the wing to the wing seat. Pin the wing down until the glue sets. Double check the correct alignment! Sand a narrow flat strip on the bottom of the centre of the horizontal tailplane. Apply thick cyano and attach the horizontal tailplane to the tail boom. Check the correct alignment relative to the wing and fuselage looking from above and from behind. Once satisfied, apply accelerator to cure the glue instantly. Glue the vertical fin in place in the same manner.