Translations:KAVAN Alpha 1500mm - Instruction manual/189/fr: Difference between revisions

From KAVAN RC Wiki
(Created page with "B) Déplacez lentement le manche des gaz vers le haut, l'hélice doit commencer à tourner dans le sens des aiguilles d'une montre (en regardant de derrière). Si elle tourne dans la direction opposée, ramenez le manche des gaz en arrière, débranchez la batterie de vol et échangez deux des trois câbles entre le moteur et l'ESC. Vérifiez à nouveau. Répétez la calibration de la plage des gaz de l'ESC. Puis vérifiez à nouveau. {{Note|type=info|text='''Remarque :'...")
 
 
(One intermediate revision by the same user not shown)
(No difference)

Latest revision as of 12:58, 15 October 2025

Message definition (KAVAN Alpha 1500mm - Instruction manual)
B) Slowly move the throttle stick up, the prop should start rotating clockwise (looking from behind). If it spins in the opposite direction, pull the throttle stick back, disconnect the flight battery and swap any two of the three cables between the motor and the ESC. The re-check again. Repeat the ESC throttle range calibration. Then re-check again.
{{Note|type=info|text='''Note:''' If the motor does not respond to the throttle stick advance, check the model power cable connection and the state of charge of your battery.}}
{{Note|type=error|text='''Caution:'''  Keep away from the propeller once the battery is connected to the model. Do not try to stop the propeller with your hands or anything else.}}
[[File:ALPHA_-_CG.png|right|frameless|250x250px]]
'''8. The centre of gravity'''

B) Déplacez lentement le manche des gaz vers le haut, l'hélice doit commencer à tourner dans le sens des aiguilles d'une montre (en regardant de derrière). Si elle tourne dans la direction opposée, ramenez le manche des gaz en arrière, débranchez la batterie de vol et échangez deux des trois câbles entre le moteur et l'ESC. Vérifiez à nouveau. Répétez la calibration de la plage des gaz de l'ESC. Puis vérifiez à nouveau.

Remarque : Si le moteur ne répond pas lorsque le manche des gaz est déplacé, vérifiez la connexion du câble d'alimentation du modèle et l'état de charge de votre batterie.
Attention : Éloignez-vous de l'hélice une fois la batterie branchée au modèle. Ne tentez pas d'arrêter l'hélice avec vos mains ou quoi que ce soit d'autre.

8. Le centre de gravité